- Special Offer!
- Out-of-Stock
Manufacturer
Enes Magnesy
Length
120 [mm]
Width
80 [mm]
Height
33 [mm]
Magnet type
Ferrite
Maximal hoisting capacity
45 [kg]
Magnetic field in geometrical center of the magnetic pole surface
0,25 [T]
Maximum working temperature
250 [°C]
Housing
stainless steel, AISI 304 / EN 1.4301, approved for contact with food
Waterproof
class IP67
Weight
2.2 [kg]
Performance parameters
The gap between the magnet and the iron plate significantly reduces the force needed to detach the magnet from the plate.
Holding magnets for galvanizing plant are used for holding steel elements during the electroplating work. It has a relatively high pull force, it is ideal for securely hold both small and large and heavy elements. It also may be used to move small steel details from one place to another. The solid construction ensures long-term use. The magnet for the galvanizing has a waterproof housing made of acid-proof steel.
This holding magnet is waterproof closed in a housing made of acid-proof steel. In this way the magnet is not exposed to impacts or contact with chemicals.
In the holding magnet sintered ferrite magnets were used.
The maximum working temperature for holding magnets involving ferrite magnets is 250o[C].
The pull force given refers to hoisting capacity measured in optimal conditions, by using as a backing plate a sheet made of low-carbon steel, 70 [mm] thick, of smooth surface and with the force acting perpendicularly, in room temperature.
Notice: the pull force given should be treated as only a comparative value. An actual pull force depends on the following factors:
- air gap (a distance) between holding magnet and an attracted element
- material, of which an attracted element is made (the higher carbon proportion in steel, the smaller pull force)
- surface of an attracted element (the smoother the surface, bigger the pull force)
- direction of acting of detaching force (the biggest pull force is obtained with perpendicular acting of detaching force)
- thickness of an attracted element (the element cannot be too thin, because in such case part of magnetic flux is not used for closing of a magnetic circuit)
- working temperature.
We generally recommend individual checking of the holding magnet in any specific working conditions.
Height including an eye: 125 mm
umwsz120x80x33f
Specific References