- Out-of-Stock
Manufacturer
Enes Magnesy
Length
160 [mm]
Width
100 [mm]
Height
30 [mm]
handle length
235 [mm]
Thread type
wewnętrzny, M8
Magnet type
Neodymium
Maximal hoisting capacity
800 [kg]
recommended maximum thickness of the metal sheet
Coating
Zinc (Zn)
Maximum working temperature
≤ 80 [°C]
with easier detachment
yes
handling mode
manual use
With handle
yes
Weight
4.66 [kg]
- air gap (a distance) between holding magnet and an attracted element
- material, of which an attracted element is made (the higher carbon proportion in steel, the smaller pull force)
- surface of an attracted element (the smoother the surface, bigger the pull force)
- direction of acting of detaching force (the biggest pull force is obtained with perpendicular acting of detaching force)
- thickness of an attracted element (the element cannot be too thin, because in such case part of magnetic flux is not used for closing of a magnetic circuit)
- working temperature.
Performance parameters
The maximum pull force: ~800 [kg]
The maximum slide force: ~200 [kg]
Two threaded holes M8.
Length of handle: ~235 [mm].
Total width with handle: ~140 [mm].
Holding magnet with facilitated separation is used for secure of molds on vibro-tables during production of concrete elements.
In the holding magnet sintered neodymium magnets (NdFeB) were used. The maximum working temperature for holding magnets involving neodymium magnets is 80o[C].
The pull force given refers to hoisting capacity measured in optimal conditions, by using as a backing plate a sheet made of low-carbon steel, 10 [mm] thick, of smooth surface and with the force acting perpendicularly, in room temperature.
Notice: the pull force given should be treated as only a comparative value. An actual pull force depends on the following factors:
We generally recommend individual checking of the holding magnet in any specific working conditions.
Weight of the holding magnet: ~4,7 [kg]
The maximum pull force: ~800 [kg]
The maximum slide force: ~200 [kg]
Two threaded holes M8.
Length of handle: ~235 [mm].
Total width with handle: ~140 [mm].
Holding magnet with facilitated separation is used for secure of molds on vibro-tables during production of concrete elements.
In the holding magnet sintered neodymium magnets (NdFeB) were used. The maximum working temperature for holding magnets involving neodymium magnets is 80o[C].
The pull force given refers to hoisting capacity measured in optimal conditions, by using as a backing plate a sheet made of low-carbon steel, 10 [mm] thick, of smooth surface and with the force acting perpendicularly, in room temperature.
Notice: the pull force given should be treated as only a comparative value. An actual pull force depends on the following factors:
- air gap (a distance) between holding magnet and an attracted element
- material, of which an attracted element is made (the higher carbon proportion in steel, the smaller pull force)
- surface of an attracted element (the smoother the surface, bigger the pull force)
- direction of acting of detaching force (the biggest pull force is obtained with perpendicular acting of detaching force)
- thickness of an attracted element (the element cannot be too thin, because in such case part of magnetic flux is not used for closing of a magnetic circuit)
- working temperature.
We generally recommend individual checking of the holding magnet in any specific working conditions.
Weight of the holding magnet: ~4,7 [kg]
umzuo160x100x30n
Specific References