• Special Offer!

Magnet, diameter 6 mm, M3 internal thread, height 6 mm, neodymium

Magnet, diameter 6 mm, M3 internal thread, height 6 mm, neodymiumMagnet, diameter 6 mm, M3 internal thread, height 6 mm, neodymium€0.97

Your Query is sent.

  •     *Required Fields

Loading

Of Price Net Price Gross
1 pcs. €0.97 €1.19
16 pcs. €0.37 €0.46
100 pcs. €0.33 €0.41
450 pcs. €0.28 €0.34

Lowest price from 30 days before the promotion: €1.26 Net (€1.55 Gross)

Quantity
Available Quantity: 454 pcs.

Product symbol: HM 6 x 6 / M3 / N

Ask a question
Performance parameters

External diameter

6 [mm]

Height

6 [mm]

Thread type

internal, M3

Magnet type

Neodymium

Maximal hoisting capacity

0,7 [kg]

The pull force given refers to hoisting capacity measured in optimal conditions, by using as a backing plate a sheet made of low-carbon steel, 10 [mm] thick, of smooth surface and with the force acting perpendicularly, in room temperature.

Notice: the pull force given should be treated as only a comparative value. An actual pull force depends on the following factors:

  • air gap (a distance) between holding magnet and an backing plate (in some conditions even a very narrow gap, i.e. 0,5 [mm] can result in decrease in pull force by a half)
  • material, of which a backing plate is made (the higher carbon proportion in steel, the smaller pull force)
  • surface of a backing plate (the smoother the surface, the bigger pull force)
  • direction of acting of detaching force (the biggest pull force is obtained with perpendicular acting of detaching force)
  • thickness of a backing plate (the backing plate cannot be too thin, because in such case part of magnetic flux is not used for closing of a magnetic circuit)
  • working temperature (in temperature of 80°[C] pull force can be lower of up to 20 per cent)

Coating

Zinc (Zn)

Maximum working temperature

≤ 80 [°C]

Weight

1,1 [g]

Holding magnets are simple magnetic circuits composited of a magnet and a steel housing. Because of that, in the holding magnets both magnet poles are used (one works directly, and the second saturates the housing, which also act on the attracted element), they are characterized by a relatively high pull force parallel to significantly reducing of the operating range.

In the holding magnet sintered neodymium magnet was used. Max. working temperature for holding magnets involving neodymium magnets is 80°[C].

You will find attached a dimensional drawing of the holding magnet.

Magnet in housing, diameter ⌀6 mm, with M3 internal thread, height 6 mm, neodymium (magnetic holder)

A small, round neodymium magnet is glued into an iron casing in the shape of a cup, or pot. Due to its brittleness, it is not possible to thread the hole in the magnet, so the thread is made in the iron bottom of the casing. The magnet does not protrude over the rim, edge, edge of the iron cup, and is not flush. Thus, it is more protected against impacts. This pot magnet or encapsulated magnet has a diameter equal to its height and this is 6 mm. The load capacity is approximately 0.7 kg. It is the smallest neodymium magnet with internal thread.

ttttttttttttttttttt

um6x6m3n
454 Items
Specific References